Getting started
R&S
®
RTE
116User Manual 1326.1032.02 ─ 20
3. To change the size of the new diagram, drag its edge to the required position.
Remote commands: see Chapter 18.7.2.3, "Smartgrid", on page 1094.
3.4.6 Using the signal bar
The signal bar can hold a large number of signal and result icons. Signal icons repre-
sent the waveforms, serial buses and parallel buses, while result icons are minimized
result boxes showing measurement and search results.
To scroll the signal bar
If the signal bar contains more than four icons, not all icons are visible on the display.
► Touch one of the signal icons and move it up or down until the required icon
appears.
To switch on and off the signal bar
If you need the complete screen to see the diagrams and results, you can switch off
the signal bar completely.
► Tap the "Show signal bar" icon on the toolbar.
Alternatively, tap "Signal Bar" on the "Display" menu.
Operating the instrument
To Next Page
Loading...
