Rohde & Schwarz RTE Series - Decode Results

Remote control commands
R&S
®
RTE
1758User Manual 1326.1032.02 ─ 20
BUS<m>:CMSB:FILTer:IMIN <Frame>, <Field>, <Data>
Specifies the index, or sets the start value of an index range.
Suffix:
<m>
.
1..4
Setting parameters:
<Frame>
<Field>
<Data>
Usage: Setting only
BUS<m>:CMSB:FILTer:IOPerator <Frame>, <Field>, <Operator>
Sets the operator for the index in the selected field of the selected frame.
Suffix:
<m>
.
1..4
Setting parameters:
<Frame>
<Field>
<Operator> ANY | OFF | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | RANGe
ANY = OFF
The index of the required pattern is not relevant.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
This condition requires one endpoint value to be set using
BUS<m>:CMSB:FILTer:IMIN.
INRange | RANGe
This condition requires a range of endpoint values to be set
using BUS<m>:CMSB:FILTer:IMAX and BUS<m>:CMSB:
FILTer:IMIN.
Usage:
Setting only
18.17.15.4 Decode results
In all BUS<m>:CSMB:RESult<n> commands, the suffix <m> selects the serial bus, the
suffix <n> selects the result number in the decode table, and the suffix <o> selects the
cell number.
The following is an example for a set of query commands for bus 1 and result 1 is
shown in the following, together with examples for outcomes of these queries:
●
:BUS1:CMSB:RCOunt? !5
●
:BUS1:CMSB:RESult1:STATe? !OK
Protocols