Protocol analysis
R&S
®
RTE
656User Manual 1326.1032.02 ─ 20
channel value is a measurement result that creates a point on the trend curve. You can
configure the number of points that builds the complete trend curve.
Figure 13-43: Trend (Diagram3) and track of an audio signal
13.8.6.1 Displaying and configuring the trend
If an audio bus is configured, you can set up the trend measurement for audio chan-
nels. The following procedure describes the complete trend setup using the "Meas"
menu.
1. On the "Meas" menu, select "Setup".
2. Select the "Category" = "Protocol".
3. Select the "Source" of the measurement: "Serial bus". Select the bus configured for
the audio signal.
4. Enable "State".
5. Select the "Audio channel" for which you want to analyze the trend.
Audio signals (option R&S
RTE-K5)
To Next Page
Loading...
