Measurements
R&S
®
RTE
386User Manual 1326.1032.02 ─ 20
are are measured and included in the histogram. If the histogram is based on long-
term measurement, it is shown in the long-term diagram.
Figure 8-12: Statistical results and measurement histogram of an amplitude measurement
See also: "Enable (Histogram)" on page 388.
8.2.10.4 Track
The track is a waveform that shows measurement values in time-correlation to the
measured signal. It is the graphical interpretation of all measurement values of a single
acquisition.
The track is available for most amplitude/time measurements (except for High, Low,
Amplitude, Max, Min, Peak to peak, Mean, RMS, S-dev, Pos. and Neg. overshoot, and
Area), and for jitter measurements.
Enabling the track enables also the Continuous auto scale and Measure all events in
each acquisition.
To analyze the track, you can use cursor measurements and zoom.
Automatic measurements
To Next Page
Loading...
