Rohde & Schwarz RTE Series - Page 388

Measurements
R&S
®
RTE
388User Manual 1326.1032.02 ─ 20
Measurement for analysis / math
Shows the selected measurement type, see also "Measurement type" on page 337.
Statistics / Enable
Enables the calculation and display of statistical results.
Remote command:
MEASurement<m>:STATistics[:ENABle] on page 1289
Enable (Long term)
Enables long-term measurement of the main measurement.
Remote command:
MEASurement<m>:LTMeas[:STATe] on page 1294
Enable (Histogram)
Displays a histogram of measurement results - the cumulative occurrence distribution
of measurement results in a graphic. Enabling the histogram enables also the statistics
and "Measure all events in each acquisition".
Remote command:
MEASurement<m>:STATistics:HISTogram on page 1290
Number of bins
Sets the number of bins - the number of vertical bars that build the histogram.
If "Continuous auto scale" is enabled, the instrument determines the number of bins
based on the timebase, the current measurements, and other settings. To set the num-
ber of bins manually, disable "Continuous auto scale".
Remote command:
MEASurement<m>:STATistics:HBINs on page 1291
Automatic measurements