Rohde & Schwarz RTE Series - MIL-STD-1553 Label List; Triggering on MIL-STD-1553

Protocol analysis
R&S
®
RTE
670User Manual 1326.1032.02 ─ 20
Max Response ← Error Condition
Checks and sets a value for the maximum response time between the last bit of a word
and the following status word sync. The time is measured between the mid bit zero
crossings. According to the standard, the RT shall respond to a valid command word
within the time period of 4 to 12 μs.
The max response time is relevant for protocol configuration and error trigger.
If "Max Response" is enabled, the instrument detects the specified gap during decod-
ing. If the trigger type "Error condition" is selected in addition, the instrument triggers
when the response time is longer than specified.
Remote command:
BUS<m>:MILStd:MAXResponse:BITS on page 1607
BUS<m>:MILStd:MAXResponse:SELect on page 1607
TRIGger<m>:MILStd:MAXResponse:BITS on page 1616
TRIGger<m>:MILStd:MAXResponse:SELect on page 1617
13.9.3.2 Triggering on MIL-STD-1553
Prerequisites: A bus is configured for the MIL-STD-1553 signal to be analyzed.
1. Press the [PROTOCOL] key and select the "Trigger" tab.
2. Press the "Select" button. The "Source" button is shown.
3. Tap the "Source" button and select the "Serial bus" trigger source.
4. Select the serial bus that is set to MIL-STD-1553.
5. Select the "Trigger type".
6. For more complex trigger types, enter the data pattern conditions.
For details, see Chapter 13.9.3.1, "Trigger settings MIL-STD-1553", on page 663.
13.9.4 MIL-STD-1553 label list
Label lists are protocol-specific. A MIL-STD-1553 label file contains four values for
each identifier:
●
"RTA": hexadecimal remote terminal address value
●
"Sub Addr": hexadecimal sub address value
●
"Sub Address Label Name": the label name corresponding to the value of the sub-
address.
●
"Symbolic label": symbolic name of addressed device, specifying the device func-
tion, and the label of the sub address.
Example: MIL PTT file
# -----------------------------------------------------------
# Labels for MIL.1553 protocol
# Column order: RT address, RT label, Subaddress, Subaddress Label
# ---------------------------------------------------------------------
MIL-1553 (option R&S
RTE-K6)