Rohde & Schwarz RTE Series - Spectrogram Configuration Settings

Spectrum analysis
R&S
®
RTE
420User Manual 1326.1032.02 ─ 20
5. To view a different waveform from the spectrogram, move the time lines in the
spectrogram.
9.2.4 Spectrogram configuration settings
Access: [MATH] > "FFT Setup"
Spectrograms are only available if the option R&S RTE-K18 is activated. Furthermore,
a math (FFT) waveform must be configured and enabled.
See Chapter 9.1.2, "Configuring spectrum waveforms", on page 402.
Enable
.........................................................................................................................420
Time line 1/2................................................................................................................420
Show lines permanently..............................................................................................421
Enable
Enables the spectrogram display.
If enabled, a new signal icon for the spectrogram is displayed on the signal bar
("SGx").
Remote command:
CALCulate:MATH<m>:FFT:SPECtrogram:STATe on page 1330
Time line 1/2
A time line marks a single spectrum in the spectrogram, that is: the power vs frequency
results for the data acquired at a specific time. After enabling a time line, the results for
that time are displayed in the spectrum diagram. A small arrow icon labeled "T1" / "T2"
indicates the position of the time line in the spectrogram. A new signal icon is displayed
on the signal bar for each time line ("SGxTL1|2").
Spectrum Analysis (option R&S
RTE-K18)