Rohde & Schwarz RTE Series - Page 1330

Remote control commands
R&S
®
RTE
1330User Manual 1326.1032.02 ─ 20
CALCulate:MATH<m>:FFT:USEColtab <UseColorTable>
If enabled, the selected waveform is displayed according to its assigned color table.
For information on the available color tables, see Chapter 4.4.2.2, "Color tables",
on page 146.
If this option is disabled, the preset color of the selected channel source is displayed,
and the intensity of the specific signal color varies according to the cumulative occur-
rence of the values.
Suffix:
<m>
.
1..8
Parameters:
<UseColorTable> ON | OFF
*RST: OFF
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:SPECtrogram:STATe <State>
Enables the spectrogram display for a math waveform.
Suffix:
<m>
.
1..8
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
CALCulate:MATH<m>:FFT:SPECtrogram:TIMeline<n>:POSition <Position>
Defines the position of one of the two possible time lines in a spectrogram. The time
line must be enabled first, using the CALCulate:MATH<m>:FFT:SPECtrogram:
TIMeline<n>:STATe command.
Suffix:
<m>
.
1..8
<n> 1..2
Parameters:
<Position> The position of the time line is defined by the index of the data
acquisition in the history. How many acquisitions are available
depends on the history settings.
Range: 0 to 4294967295
Increment: 1
*RST: 0
Usage: Asynchronous command
Spectrum analysis