Protocol analysis
R&S
®
RTE
648User Manual 1326.1032.02 ─ 20
Remote command:
TRIGger<m>:I2S:WSSLope on page 1601
13.8.3.2 Triggering on audio signals
Prerequisites: An Audio bus is configured, see Chapter 13.8.2.2, "Configuring audio
protocol", on page 644.
1. Press the [PROTOCOL] key and select the "Trigger" tab.
2. Press the "Select" button. The "Source" button is shown.
3. Tap the "Source" button and select the "Serial bus" trigger source.
4. Select the serial bus that is set to Audio.
5. Select the "Trigger type".
6. For more complex trigger types, enter the data, frame or word select conditions.
For details, see Chapter 13.8.3.1, "Audio trigger", on page 644
13.8.4 Audio decode results
When the configuration of the serial bus is complete, the signal can be decoded:
1. In the "Protocol" dialog > "Decode" tab, enable "Decode".
2. In the "Protocol" dialog > "Display" tab, select additional result display settings:
"Show decode table" and "Show binary signals".
For a description of the display settings, see also Chapter 13.1.3, "Display",
on page 515.
The instrument captures and decodes the signal according to the standard definition
and the configuration settings.
The color-coding of the various protocol sections and errors simplifies the interpretation
of the visual display. The decode information condenses or expands, depending on the
horizontal scale. Various data formats are available to show the result values.
The decoding process considers the "Bit order" configuration setting of the signal and
displays the binary result MSB first. Binary values in the combs of the decoded signal
also consider the "Binary bit order" setting in the "Display" tab. Thus, you can read the
bits of an LSB first signal in LSB first order in the combs while the results table displays
the correct values MSB first.
Audio signals (option R&S
RTE-K5)
To Next Page
Loading...
