Rohde & Schwarz RTE Series - Page 1444

Remote control commands
R&S
®
RTE
1444User Manual 1326.1032.02 ─ 20
Parameters:
<RepeatedStart> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:STCNdition <SearchName>,<Stop>
SEARch:TRIGger:I2C:STCNdition? <SearchName>
Enables the search for the start of the message.
Parameters:
<Stop> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:NACKnowledge <SearchName>,<NoAcknowledge>
SEARch:TRIGger:I2C:NACKnowledge? <SearchName>
Searches for missing address acknowledge bits.
Parameters:
<NoAcknowledge> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:I2C:SADDress <SearchName>,<Address>
SEARch:TRIGger:I2C:SADDress? <SearchName>
Enables the search for one specific address condition or for a combination of address
conditions.
To define the address condition, use the following commands:
●
SEARch:TRIGger:I2C:ACONdition on page 1445
●
SEARch:TRIGger:I2C:ADDRess on page 1446
●
SEARch:TRIGger:I2C:ADDTo on page 1446
●
SEARch:TRIGger:I2C:AMODe on page 1446
●
SEARch:TRIGger:I2C:ACCess on page 1447
Parameters:
<Address> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
Protocols