Rohde & Schwarz RTE Series - Page 689

Protocol analysis
R&S
®
RTE
689User Manual 1326.1032.02 ─ 20
Type
The search criterion is defined by "Type". All trigger types are also available for search.
Additional search parameters are provided under "Detailed Search Parameter Setup".
"Word Start"
Searches for the start word.
"Word Stop"
Searches for the stop word.
"Label + Data"
Searches for a defined word format. You can search for the label, the
data, the SDI, and SSM bits separately.
For details, see "Label + Data" on page 683.
"Error condition"
Identifies various errors in the frame, see "Error Conditions"
on page 684.
Remote command:
SEARch:TRIGger:ARINc:TYPE on page 1643
Label setup: Condition, Label min, Label max
The label setup consists of the condition and one or two label patterns.
The label setup settings are the same as in the ARINC trigger setup, see "Label setup:
Condition, Label Min, Label Max" on page 683.
Remote command:
SEARch:TRIGger:ARINc:LABel:CONDition on page 1643
SEARch:TRIGger:ARINc:LABel:MIN on page 1643
SEARch:TRIGger:ARINc:LABel:MAX on page 1644
Data setup: Condition, Data min, Data max
The data setup consists of the condition and one or two data patterns.
The data setup settings are the same as in the ARINC trigger setup, see "Data setup:
Condition, Data Min, Data Max" on page 683.
Remote command:
SEARch:TRIGger:ARINc:DATA:CONDition on page 1643
SEARch:TRIGger:ARINc:DATA:MIN on page 1643
SEARch:TRIGger:ARINc:DATA:MAX on page 1644
SDI / SSM setup: SDI, SSM
The SDI / SSM setup consists of the SDI and SSM.
The SDI / SSM setup settings are the same as in the ARINC trigger setup, see "SDI /
SSM" on page 684.
Remote command:
SEARch:TRIGger:ARINc:SDI on page 1644
SEARch:TRIGger:ARINc:SSM on page 1644
Error Condition
Selects the error type to be searched for. You can select one or more error types as
search condition.
The error types are the same as in the ARINC trigger setup, see "Error Conditions"
on page 684
ARINC 429 (option R&S
RTE-K7)