Rohde & Schwarz RTE Series - Page 1755

Remote control commands
R&S
®
RTE
1755User Manual 1326.1032.02 ─ 20
BUS<m>:CMSB:FILTer:DMAX <Frame>, <Field>, <Data>
Sets the end value of a data pattern range if BUS<m>:CMSB:FILTer:DOPerator is
set to INRange or OORange.
Suffix:
<m>
.
1..4
Setting parameters:
<Frame>
<Field>
<Data>
Usage: Setting only
BUS<m>:CMSB:FILTer:DMIN
<Frame>, <Field>, <Data>
Specifies the data pattern, or sets the start value of a data pattern range.
Suffix:
<m>
.
1..4
Setting parameters:
<Frame>
<Field>
<Data>
Usage: Setting only
BUS<m>:CMSB:FILTer:DOPerator <Frame>, <Field>, <Operator>
Sets the operator for the data pattern.
Suffix:
<m>
.
1..4
Setting parameters:
<Frame>
<Field>
<Operator> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
ANY = OFF
The data of the required pattern is not relevant.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
This condition requires one endpoint value to be set using
BUS<m>:CMSB:FILTer:DMIN.
Protocols