Rohde & Schwarz RTE Series - Page 1098

Remote control commands
R&S
®
RTE
1098User Manual 1326.1032.02 ─ 20
DISPlay:DIAGram:GRID <Show>
If enabled, a grid is displayed in the diagram area.
Parameters:
<Show> ON | OFF
Usage: Asynchronous command
DISPlay:DIAGram:CROSshair <Crosshair>
If selected, a crosshair is displayed in the diagram area. A crosshair allows you to
select a specific data point by its co-ordinates.
Parameters:
<Crosshair> ON | OFF
Usage: Asynchronous command
DISPlay:DIAGram:FINegrid <ShowFineScale>
If ON, the crosshair is displayed as a ruler with scale markers. If OFF, the crosshair is
shown as dashed lines.
Parameters:
<ShowFineScale> ON | OFF
Usage: Asynchronous command
DISPlay:DIAGram:LABels <ShowLabels>
If enabled, labels mark values on the x- and y-axes in specified intervals in the dia-
gram.
Parameters:
<ShowLabels> ON | OFF
Usage: Asynchronous command
DISPlay:DIAGram:TITLe <DiagTitleSt>
If enabled, the tab titles of all diagrams are displayed: "Diagram1", "Diagram2" ...
If disabled, the tab titles are not shown except for those in a tabbed diagram. In tabbed
diagrams, the tab titles are required to change the tabs.
Parameters:
<DiagTitleSt> ON | OFF
Usage: Asynchronous command
Instrument setup