Rohde & Schwarz RTE Series - Page 1166

Remote control commands
R&S
®
RTE
1166User Manual 1326.1032.02 ─ 20
Z1V1 | Z1V2 | Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 | Z1I4 | Z2V1 |
Z2V2 | Z2V3 | Z2V4 | Z2I1 | Z2I2 | Z2I3 | Z2I4
Input channels of R&S RT-ZVCmulti-channel power probe. Only
available in the A-trigger with trigger type EDGE.
DIFF1 | DIFF2 | COMMON1 | COMMON2
Differential signals
*RST: CHAN1
Usage: Asynchronous command
TRIGger<m>:TYPE <Type>
Selects the trigger type to trigger on analog channels or the external trigger input.
See also: Chapter 6.3, "Trigger types", on page 241.
To trigger on digital channels and parallel buses, use TRIGger<m>:PARallel:TYPE.
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger, 3 = R-trigger
For suffixes 2 and 3, the following trigger types are availabe:
EDGE, GLITch, WIDTh, RUNT, WINDow, TIMeout, INTerval,
SLEWrate.
Parameters:
<Type> EDGE | GLITch | WIDTh | RUNT | WINDow | TIMeout | INTerval |
SLEWrate | STATe | PATTern | ANEDge | SERPattern | TV | |
DATatoclock
Most of the type values are self-explanatory.
DATatoclock
Data2Clock: analyzes the relative timimg between a data signal
and the synchronous clock signal. For trigger settings, see
Chapter 18.9.10, "Data2Clock", on page 1183.
ANEDge
Edge trigger for external trigger input. Only available if the trig-
ger source is the external trigger input. This trigger type uses the
analog input signal. For trigger settings, see Chapter 6.8.2,
"External trigger setup", on page 275.
SERPattern
Serial pattern for signals with serial data patterns in relation to a
clock signal. For trigger settings, see Chapter 18.9.13, "Serial
pattern trigger", on page 1190
*RST:
EDGE
Usage: Asynchronous command
TRIGger<m>:LEVel<n>[:VALue] <Level>
Sets the trigger level for the specified event and source.
Trigger