Rohde & Schwarz RTE Series - Page 1262

Remote control commands
R&S
®
RTE
1262User Manual 1326.1032.02 ─ 20
<n> 1..2
Selects the source number.
Parameters:
<EdgeCntDirct> FRFI | FRLA
FRFI - FRom FIrst, counting starts with the first edge of the
waveform.
FRLA - FRom LAst, counting starts with the last edge of the
waveform.
*RST: FRFI
Usage: Asynchronous command
MEASurement<m>:AMPTime:DELay<n>:ECOunt <EdgeIndex>
Sets the number of the edge that is relevant for delay measurement for each source.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
<n> 1..2
Selects the source number.
Parameters:
<EdgeIndex> Edge number
Range: 1 to 100000
Increment: 1
*RST: 1
Usage: Asynchronous command
MEASurement<m>:AMPTime:DELay<n>:SLOPe <Slope>
Sets the edge of each source, between which the delay is measured.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
<n> 1..2
Selects the source number.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
Automatic measurements