Rohde & Schwarz RTE Series - Page 1299

Remote control commands
R&S
®
RTE
1299User Manual 1326.1032.02 ─ 20
MEASurement<m>:PROTocol:MBITrate:FLD <FieldName>
Sets the type of field for the frame of the main bit rate protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<FieldName>
MEASurement<m>:PROTocol:MBITrate:FRM <FrameName>
Sets the type frame for the main bit rate protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<FrameName>
MEASurement<m>:PROTocol:MBITrate:VAL <MainBtRateIdVal>
Sets the field value of the frame for the main bit rate protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<MainBtRateIdVal>
Usage: Asynchronous command
MEASurement<m>:PROTocol:SBITrate:FLD <FieldName>
Sets the type of field for the frame of the secondary bit rate protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement: MEASurement<m>"
on page 1249.
Parameters:
<FieldName>
MEASurement<m>:PROTocol:SBITrate:FRM <FrameName>
Sets the type frame for the secondary bit rate protocol measurement.
Automatic measurements