Rohde & Schwarz RTE Series - Page 1309

Remote control commands
R&S
®
RTE
1309User Manual 1326.1032.02 ─ 20
REFLevel<m>:LDETection <Mode>
Defines whether the reference level is configured manually or automatically.
Suffix:
<m>
.
Valid suffix numbers: 2 to 21, 61 to 68, 108 to 111, 115 to 118
Source waveform of the measurement, see Chapter 18.4.1,
"Waveform suffix", on page 1072.
Parameters:
<Mode> AUTO | MANual
Example:
REFLevel2:LDETection MANual
Sets manual level configuration for Ch1. C1W1 corresponds to
suffix number 2.
Example: See: Chapter 18.3.2.2, "Setting reference levels", on page 1057
Usage: Asynchronous command
REFLevel<m>:LMODe
<Mode>
Defines whether the reference is configured using absolute or relative values.
Suffix:
<m>
.
Valid suffix numbers: 2 to 21, 61 to 68, 108 to 111, 115 to 118
Source waveform of the measurement, see Chapter 18.4.1,
"Waveform suffix", on page 1072.
Parameters:
<Mode> ABS | REL
Example:
REFLevel2:LMODe ABS
Sets definition of reference levels to absolute values for Ch1.
C1W1 corresponds to suffix number 2.
Example: See: "Manual reference level definition using relative values"
on page 1057
Usage: Asynchronous command
REFLevel<m>:RELative:MODE <Mode>
The lower, middle and upper reference levels, defined as percentages of the high sig-
nal level.
Suffix:
<m>
.
Valid suffix numbers: 2 to 21, 61 to 68, 108 to 111, 115 to 118
Source waveform of the measurement, see Chapter 18.4.1,
"Waveform suffix", on page 1072.
Parameters:
<Mode> FIVE | TEN | TWENty | USER
FIVE
5/50/95
Automatic measurements