Rohde & Schwarz RTE Series - Page 1618

Remote control commands
R&S
®
RTE
1618User Manual 1326.1032.02 ─ 20
TRIGger<m>:MILStd:STATus:BUSY <BusyFlag>
Triggers on the state of the busy bit of the status word if TRIGger<m>:MILStd:TYPE
is set to STATword.
Parameters:
<BusyFlag> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:DBCaccept <DynBusControl>
Triggers on the state of the dynamic bus control accept bit of the status word if
TRIGger<m>:MILStd:TYPE is set to STATword.
Parameters:
<DynBusControl> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:INSTrument
<InstFlag>
Triggers on the state of the instrumentation bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<InstFlag> ONE | ZERO | DC
*RST: ZERO
TRIGger<m>:MILStd:STATus:MERRor <MessageError>
Triggers on the state of the message error bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<MessageError> ONE | ZERO | DC
*RST: DC
TRIGger<m>:MILStd:STATus:SREQuest <ServiceRequest>
Triggers on the state of the the service request bit of the status word if TRIGger<m>:
MILStd:TYPE is set to STATword.
Parameters:
<ServiceRequest> ONE | ZERO | DC
*RST: DC
Protocols