Rohde & Schwarz RTE Series - Page 1766

Remote control commands
R&S
®
RTE
1766User Manual 1326.1032.02 ─ 20
Setting parameters:
<SearchName>
<Frame>
<Field>
<Enabler> ON | OFF
Usage: Setting only
SEARch:TRIGger:CMSB:FRENable <SearchName>,<Frame>, <Enabler>
Enables or disables the specific frame to be searched for.
Setting parameters:
<SearchName>
<Frame>
<Enabler> ON | OFF
Usage: Setting only
SEARch:TRIGger:CMSB:BIT <SearchName>,<Frame>, <Field>, <Bit>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:BIT <SearchName>,<BitState>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:BIT? <SearchName>
Sets the bit state of a field to be searched that only consists of one bit.
Suffix:
<m>
.
*
<n> *
Parameters:
<BitState> ONE | ZERO | DC
ONE
1
ZERO
0
DC
"Do not care" (DC) = X
*RST: DC
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CMSB:DMAX <SearchName>,<Frame>, <Field>, <Data>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:DMAX <SearchName>,<DataMax>
SEARch:TRIGger:CMSB:FRAMe<m>:FLD<n>:DMAX? <SearchName>
Sets the end value of a data pattern range if SEARch:TRIGger:CMSB:FRAMe<m>:
FLD<n>:DOPerator is set to INRange or OORange.
Protocols