Rohde & Schwarz RTE Series - Page 1792

Remote control commands
R&S
®
RTE
1792User Manual 1326.1032.02 ─ 20
HSIC
USB high speed inter-chip (HSIC) protocol (480 Mbit/s)
*RST: LOW
BUS<m>:USB:DPLus:SOURce <SourceDplus>
Selects the source for the D+ data signal (in USB low speed and USB full speed proto-
col, only).
Suffix:
<m>
.
1..4
Parameters:
<SourceDplus> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C1W1
Usage: Asynchronous command
BUS<m>:USB:DMINus:SOURce <SourceDminus>
Selects the source for the D- data signal (in USB low speed and USB full speed proto-
col, only).
Suffix:
<m>
.
1..4
Parameters:
<SourceDminus> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C2W1
Usage: Asynchronous command
BUS<m>:USB:DIFFerential:SOURce <SrcDiff>
Selects the source for the differential signal in the USB high speed protocol.
Suffix:
<m>
.
1..4
Parameters:
<SrcDiff> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
*RST: C1W1
Usage: Asynchronous command
BUS<m>:USB:DATA:SOURce <SourceData>
Selects the source for the data signal in the USB HSIC protocol.
Protocols