Rohde & Schwarz RTE Series - Page 1807

Remote control commands
R&S
®
RTE
1807User Manual 1326.1032.02 ─ 20
SOF
Start Of Frame PID
SETUP = SETup
SETUP PID
DATA0 = DATa0
DATA0 PID, even PID
DATA1 = DATa1
DATA1 PID, odd PID
DATA2 = DATa2
DATA2 PID (only valid in USB high speed and USB HSIC proto-
cols)
MDATA = MDATa
MDATA PID (only valid in USB high speed and USB HSIC proto-
cols)
ACK
ACKnowledgment PID
NAK
Non-AcKnowledgment PID
STALL = STALl
STALL PID
NYET
Not ready YET (only valid in USB high speed and USB HSIC
protocols)
PRE
PREamble PID (only valid in USB high speed and USB HSIC
protocols)
SPLIT = SPLit
SPLIT PID (only valid in USB high speed and USB HSIC proto-
cols)
PING
PING PID (only valid in USB high speed and USB HSIC proto-
cols)
UNK
UNK = Unknown PID
*RST:
RES
Usage: Query only
BUS<m>:USB:PACKet<n>:ADDRess?
Returns the packet address for the selected serial bus and packet number.
Suffix:
<m>
.
1..4
<n> *
Protocols