Waveform analysis
R&S
®
RTE
288User Manual 1326.1032.02 ─ 20
To define multiple zoom areas graphically, simply repeat the steps described in To
define the zoom area graphically on the touchscreen - for each area. Numerically, pro-
ceed as follows:
1. On the "Display" menu, tap "Zoom".
2. Select the required tab according to the method you want to use to define the
zoom area.
3. To copy the current zoom area definition, tap the "Copy" icon.
Alternatively, tap the "Add" icon to add a new zoom area.
4. Enter a name for the new zoom diagram using the displayed on-screen keyboard.
5. Define the zoom area as described for the first zoom.
An additional zoom diagram is displayed for the new zoom area, and another rect-
angle in the original diagram indicates the new zoom area. Each rectangle in the
overview has the same color as the corresponding zoom diagram frame.
6. In the "Zoom" dialog box, enable "Zoom overlay".
The zooms are shown in the same zoom diagram, as if the zoom areas are over-
laid.
Figure 7-5: Multiple zoom diagrams. Left: separate zoom diagrams. Right: overlaid zoom
Zoom
To Next Page
Loading...
