Contents
R&S
®
RTE
29User Manual 1326.1032.02 ─ 20
17.5.1 Remote control interfaces and protocols...................................................................1041
17.5.1.1 LAN interface............................................................................................................ 1041
17.5.1.2 GPIB interface (IEC/IEEE bus interface)...................................................................1042
17.5.2 Remote settings........................................................................................................ 1043
17.5.2.1 GPIB settings............................................................................................................ 1043
17.5.2.2 Remote settings........................................................................................................ 1044
17.5.3 Starting and stopping remote control........................................................................ 1045
17.5.3.1 Starting a remote control session..............................................................................1045
17.5.3.2 Using the display during remote control....................................................................1045
17.5.3.3 Returning to manual operation..................................................................................1045
17.5.4 Remote control - status reporting system................................................................. 1046
17.5.4.1 Hierarchy of status registers..................................................................................... 1046
17.5.4.2 Contents of the status registers................................................................................ 1047
STATus:OPERation register......................................................................................1047
STATus:QUEStionable register................................................................................. 1047
17.5.4.3 Reset values of the status reporting system............................................................. 1052
18 Remote control commands.............................................................1053
18.1 Conventions used in remote command description........................................... 1053
18.2 Finding the appropriate command........................................................................ 1054
18.3 Programming examples......................................................................................... 1054
18.3.1 Display...................................................................................................................... 1055
18.3.1.1 Creating diagrams (SmartGrid)................................................................................. 1055
18.3.1.2 Creating zoom diagrams........................................................................................... 1056
18.3.2 Automatic measurements......................................................................................... 1057
18.3.2.1 Performing amplitude/time measurements............................................................... 1057
Simple frequency and amplitude measurement........................................................1057
18.3.2.2 Setting reference levels.............................................................................................1057
Manual reference level definition using relative values.............................................1057
Manual reference level definition using absolute values...........................................1058
18.3.2.3 Waveform histograms............................................................................................... 1058
Creating and reading histograms.............................................................................. 1058
Exporting histogram data to file.................................................................................1059
Transferring histogram data...................................................................................... 1059
To Next Page
Loading...
