Rohde & Schwarz RTE Series - Page 317

Waveform analysis
R&S
®
RTE
317User Manual 1326.1032.02 ─ 20
To replay history waveforms
If you want to see the complete acquisition series without any setup, simply tap "Play"
in the quick-access "History" dialog box. For specific analysis of history data, use the
hestory "Viewer" setup.
1. In the "History" configuration dialog box, select the "Viewer" tab.
2. If the history mode is off (the [HISTORY] key is not illuminated), enable "Show his-
tory".
The quick-access dialog box is displayed.
3. Define the part of the history you want to see by doing one of the following:
● Tap "Select all" to see the complete history.
● Enter the "Start Index" of the oldest acquisition to display and the "Stop Index"
of the newest acquisition to display. All waveforms between the two indexes will
be displayed.
To enter the oldest or newest acquisition for either index, tap the appropriate
button. The newest acquisition always has the index "0". The "Start index" is
always negative.
4. Tap "Play" to start.
To exit the history
► Choose one of the following ways:
● Close the quick-access "History" dialog box.
● On the "Display" menu, tap "Show history".
● In the "Viewer" tab, disable "Show history".
● Start the acquisition.
To save the history data
You can save the complete history, or some subsequent waveforms from the history, or
a single history waveform. You can also decide to save the complete waveforms, or a
part of each waveform.
1. Press the [FILE] key.
2. Select the "Save/Recall" tab.
3. Select the "Waveform" tab.
4. Tap the source icon to select the waveform you want to save.
5. If you want to save only a part of each waveform, set the "Scope".
For settings, see "Scope" on page 486.
6. Enable "Export history".
7. If you want to write the timestamps into the data file, enable "Timestamps".
8. To save one waveform out of the history memory:
a) Make sure that "Multiple Wfms" is disabled.
History