Rohde & Schwarz RTE Series - Page 321

Waveform analysis
R&S
®
RTE
321User Manual 1326.1032.02 ─ 20
To set up an XY-diagram
1. On the "Display" menu, tap "XY-diagram".
2. Enable the "XY-diagram".
3. In the "X-source" field, define the signal source that supplies the x-values of the
XY-diagram. Select one of the following:
● One of the waveforms of any channel
● A reference waveform
● The results of a mathematical function
4. In the "Y-source" field, define the signal source that supplies the y values of the XY-
diagram.
5. To switch the x- and y-values quickly, tap the "Swap XY" button.
6. To maintain a constant ratio while the x- and y-axes are adapted to the acquired
data dynamically, activate the "Constant XY-ratio" option.
If the XY-diagram is active or minimized, touch and hold the signal icon to open the
"XY-diagram" tab.
XY-diagram