Rohde & Schwarz RTE Series - Page 381

Measurements
R&S
®
RTE
381User Manual 1326.1032.02 ─ 20
"Frame"
Selects the type of frame.
"Field"
Selects the type of field.
"Value"
Sets a value for the selected field.
"Field to be
tracked"
Selects the type of field which value is tracked over time.
Remote command:
MEASurement<m>:PROTocol:FLDValue:FLD on page 1298
MEASurement<m>:PROTocol:FLDValue:FRM on page 1298
MEASurement<m>:PROTocol:FLDValue:TRCK on page 1298
MEASurement<m>:PROTocol:FLDValue:VAL on page 1298
Main bit rate / 2nd bit rate
Opens a dialog to set up the parameters for the main bit rate/ 2nd bit rate measure-
ment. You can identify a frame and a specific field value.
The types of available frames and fields depend on the enabled protocol, see
Table 8-9.
If a label list is loaded and enabled for the protocol, sometimes there are defined calcu-
lations and formatting for the displayed field value. In this case, the measurement dis-
plays the value according to the definition in the label list.
Automatic measurements