Mask testing
R&S
®
RTE
430User Manual 1326.1032.02 ─ 20
Figure 10-1: Waveform mask
Settings overview:
Common settings:
●
"Definition Type" on page 425
●
"Source" on page 425
Create mask
Creates the upper and lower mask limit from the selected reference waveform. If the
reference waveform was not defined before, it is created automatically from the mask
test "Source" waveform which is selected in the "Test Defintion" tab.
Remote command:
MTESt:WFMLupdate on page 1342
Mask test settings
To Next Page
Loading...
