Rohde & Schwarz RTE Series - Page 449

Search functions
R&S
®
RTE
449User Manual 1326.1032.02 ─ 20
Source
Defines the waveform to be searched. The source can be any analog and digital input
signal, math or reference waveform, or track. While the instrument triggers only on real
input signals, it can search also calculated and restored waveforms.
If the source is an FFT spectrum, you can perform a frequency marker search by using
the cursor measurement and defining the peak excursion. See Chapter 8.1.3.3, "Peak
search tab", on page 331.
For some serial protocol options, search on a serial bus is available. For details, see
the relevant chapters of the "Protocol Analysis" chapter.
Depending on the selected source, different search criteria are available.
Remote command:
SEARch:SOURce on page 1352
Edge, Glitch, Width, Runt, Window, Timeout, Interval, Slew rate, Data2Clock,
State, Pattern
Search criteria for analog and digital input signals, math and reference waveforms, and
tracks. For searching on digital channels, only "Edge", "Width", "Timeout" and
""Data2Clock"" criteria are available.
Tap the icon to include or exclude the search criteria in the next search. You can
enable several event types for simultaneous search.
Remote command:
SEARch:TRIGger:EDGE[:STATe] on page 1354
SEARch:TRIGger:GLITch[:STATe] on page 1354
SEARch:TRIGger:WIDTh[:STATe] on page 1354
SEARch:TRIGger:RUNT[:STATe] on page 1354
SEARch:TRIGger:WINDow[:STATe] on page 1354
SEARch:TRIGger:TIMeout[:STATe] on page 1354
SEARch:TRIGger:INTerval[:STATe] on page 1354
SEARch:TRIGger:SLEWrate[:STATe] on page 1354
SEARch:TRIGger:DATatoclock[:STATe] on page 1354
SEARch:TRIGger:STATe[:STATe] on page 1354
SEARch:TRIGger:PATTern[:STATe] on page 1354
Copy 'A Trigger'
Copies the trigger type-specific settings from the A-trigger configuration to the search
settings. The source itself is not copied.
Remote command:
SEARch:TRIGger:EDGE:ACOPy on page 1355
SEARch:TRIGger:GLITch:ACOPy on page 1355
SEARch:TRIGger:WINDow:ACOPy on page 1355
SEARch:TRIGger:WIDTh:ACOPy on page 1355
SEARch:TRIGger:RUNT:ACOPy on page 1355
SEARch:TRIGger:WINDow:ACOPy on page 1355
SEARch:TRIGger:TIMeout:ACOPy on page 1355
SEARch:TRIGger:INTerval:ACOPy on page 1355
SEARch:TRIGger:SLEWrate:ACOPy on page 1355
Search setup