Protocol analysis
R&S
®
RTE
548User Manual 1326.1032.02 ─ 20
Figure 13-8: Decode results
In the figure above, the first three frames contain two words each. The fourth frame is
incomplete, only one word of the frame was recognized
Table 13-3: Content of the "Decode results" table
Column Description
State Overall state of the frame
Frame start , Frame stop Times of frame start and frame end
Word count Number of words in the frame
MOSI values Value of the MOSI data words. The data format is
selected below the table.
MISO values Value of the MISO data words. The data format is
selected below the table.
Bit rate Value of the bit rate
Zooming on decoded results
The zoom functions allow you to analyze the decode results in more detail. If "Zoom
coupling" is enabled, the decode zoom and result table are synchronized; if you select
a row in the result table, this result is shown in the decode zoom.
For an introduction to zoom settings and setup, see:
●
Chapter 7.1.2, "Zoom settings", on page 280
●
Chapter 7.1.3, "Zooming for details", on page 284
Data format
You can select various data formats for the values displayed in the decode table and in
the combs of the decoded signal.
Remote command:
●
BUS<m>:FORMat on page 1422
Export of decode results
1. In the protocol decode table, press "Export".
SPI bus (option R&S
RTE-K1)
To Next Page
Loading...
