Protocol analysis
R&S
®
RTE
693User Manual 1326.1032.02 ─ 20
"10BASE-T"
Selects the Ethernet protocol variant 10BASE-T (standard data rate
10 Mbit/s).
Figure 13-52: Ethernet 10BASE-T protocol configuration (here with inverted
polarity)
"100BASE-TX"
Selects the Ethernet protocol variant 100BASE-TX, which provides
100 Mbit/s use data rate. Due to 4b/5b encoding, the raw data rate on
the line is 125 Mbit/s. This value is used by R&S RTE-K8 as the bit
rate default for 100BASE-TX.
Figure 13-53: Ethernet 100BASE-TX protocol configuration
Remote command:
BUS<m>:ETHernet:VARiant on page 1649
Source
Defines the source settings for the data signal.
Permitted source selections are the analog, mathematical, and reference channels.
As soon as the serial bus trigger has been selected, the only permitted source selec-
tions are the analog channels "C1" – "C4", which are required for triggering.
Remote command:
BUS<m>:ETHernet:SOURce on page 1649
Ethernet 10BASE-T and 100BASE-TX (option R&S
RTE-K8)
To Next Page
Loading...
