Rohde & Schwarz RTE Series - Page 7

Contents
R&S
®
RTE
7User Manual 1326.1032.02 ─ 20
5.1.2.2 Acquisition settings..................................................................................................... 170
5.1.2.3 Acquisition control....................................................................................................... 170
5.1.3 Horizontal system........................................................................................................171
5.1.3.1 Parameters of the horizontal system...........................................................................171
5.1.3.2 Horizontal position.......................................................................................................172
5.1.4 Probes.........................................................................................................................172
5.1.4.1 Voltage probes............................................................................................................ 173
Passive voltage probes............................................................................................... 174
Active voltage probes - general...................................................................................174
Differential active probes.............................................................................................175
5.2 Horizontal settings....................................................................................................176
5.2.1 Setup...........................................................................................................................176
5.2.2 Acquisition...................................................................................................................181
5.2.3 Fast segmentation.......................................................................................................183
5.3 Vertical settings.........................................................................................................185
5.3.1 Channels..................................................................................................................... 185
5.3.2 Coupled channels....................................................................................................... 188
5.3.3 Power calculation........................................................................................................ 189
5.4 High definition mode................................................................................................ 189
5.4.1 High definition settings................................................................................................ 190
5.4.2 Effects of the high definition mode.............................................................................. 191
5.5 Probes........................................................................................................................ 193
5.5.1 Shared probe settings................................................................................................. 194
5.5.2 Settings for the R&S probe interface (voltage probes)................................................196
5.5.3 Setup for passive probes............................................................................................ 200
5.5.4 Setup for active voltage probes...................................................................................201
5.5.4.1 R&S RT-ZS single-ended probes................................................................................202
5.5.4.2 R&S RT-ZD differential probes....................................................................................203
5.5.4.3 R&S RT-ZPR power rail probes.................................................................................. 204
5.5.4.4 R&S RT-ZHD high-voltage differential probes.............................................................205
5.5.5 Modular probes........................................................................................................... 206
5.5.5.1 Setup parameters of modular probes..........................................................................207
5.5.5.2 Termination voltage with R&S RT-ZMA40 SMA module............................................. 208