Protocol analysis
R&S
®
RTE
751User Manual 1326.1032.02 ─ 20
<sb:ENUM INDEX="5" LABEL="Channel 2 out of range low"/>
<sb:ENUM INDEX="6" LABEL="Initialization Error (Channel 2)"/>
<sb:ENUM INDEX="7" LABEL="Channel 1 and 2 Rationality Error"/>
<sb:ENUM INDEX="1025" LABEL="Slow Channel Temperature out of range high"/>
<sb:ENUM INDEX="1026" LABEL="Slow Channel Temperature out of range low"/>
<sb:ENUM INDEX="1027" LABEL="Slow Channel Temperature initialization error"/>
<sb:ENUM INDEX="1028" LABEL="Slow Channel Humidity out of range high"/>
<sb:ENUM INDEX="1029" LABEL="Slow Channel Humidity out of range low"/>
<sb:ENUM INDEX="1030" LABEL="Slow Channel Humidity initialization error"/>
<sb:ENUM INDEX="1031" LABEL="Slow Channel Barometric Pressure out of range high"/>
<sb:ENUM INDEX="1032" LABEL="Slow Channel Barometric Pressure out of range low"/>
<sb:ENUM INDEX="1033" LABEL="Slow Channel Barometric Pressure initialization error"/>
</sb:ENUM-VALUES>
</sb:SIGNAL>
</sb:SIGNALS>
</sb:FRAME>
<sb:FRAME NAME="Simu-Dual Throttle Position" STATE="ON">
<sb:SHORT-NAME>DTP</sb:SHORT-NAME>
<sb:DATA-SIZE>20</sb:DATA-SIZE>
<sb:SIGNALS>
<sb:SIGNAL ID="Channel_1">
<sb:SHORT-NAME>TPS1</sb:SHORT-NAME>
<sb:DESCRIPTION>""</sb:DESCRIPTION>
<sb:BIT-POSITION>19</sb:BIT-POSITION>
<sb:BIT-LENGTH>12</sb:BIT-LENGTH>
<sb:BYTE-ORDER>MSB</sb:BYTE-ORDER>
<sb:VALUE-TYPE>UNSIGNED_INT</sb:VALUE-TYPE>
<sb:FACTOR>1.0</sb:FACTOR>
<sb:OFFSET>0.0</sb:OFFSET>
<sb:MIN>0</sb:MIN>
<sb:MAX>10000.0</sb:MAX>
<sb:UNIT></sb:UNIT>
</sb:SIGNAL>
<sb:SIGNAL ID="Channel_2">
<sb:SHORT-NAME>TPS2</sb:SHORT-NAME>
<sb:DESCRIPTION>""</sb:DESCRIPTION>
<sb:BIT-POSITION>7</sb:BIT-POSITION>
<sb:BIT-LENGTH>8</sb:BIT-LENGTH>
<sb:BYTE-ORDER>LSB</sb:BYTE-ORDER>
<sb:FACTOR>1.0</sb:FACTOR>
<sb:OFFSET>0.0</sb:OFFSET>
<sb:MIN>0</sb:MIN>
<sb:MAX>10000.0</sb:MAX>
<sb:UNIT></sb:UNIT>
</sb:SIGNAL>
</sb:SIGNALS>
</sb:FRAME>
<sb:FRAME NAME="Dual Throttle Position" STATE="OFF">
<sb:SHORT-NAME>DTP</sb:SHORT-NAME>
<sb:DATA-SIZE>24</sb:DATA-SIZE>
SENT (option R&S
RTE-K10)
To Next Page
Loading...
