Instrument Function
R&S
®
SMU200A
363Operating Manual 1007.9845.32 ─ 15
SCPI command:
n.a.
Control and Marker List Editor
The "Control and Marker List Editor" for editing the selected control list is called up in the
"List Management" submenu of the "Custom Digital Modulation" main menu by means
of the "Edit Control List"... button.
The available marker signals and the CW, Hop, Burst Gate and Level Attenuation control
signals can be defined in the "Control and Marker List Editor".
The marker signals defined in the Control and Marker List Editor are activated by selecting
the Marker mode "CList" in the "Trigger/Marker/Clock" menu. The control signals have
to be activated by selecting an "Internal Source" in the respective setting menu, e.g. the
"Power Ramp Control" menu for the Burst Gate and Level Attenuation control signals.
The available marker/control signals are color-coded. In the left "Configure Control Sig-
nal" section, each individual signal is assigned a colour; a check in the check box shows
the marker for which the "CList" marker type has been selected and the control signal for
which the "Internal" source has been selected.
In the "Select Ramp to Edit" section the signal characteristics are graphically displayed.
The scaling of the x-axis is always adapted to the overall length of the control list to provide
constant overview of all defined ramps.
The ramps can be assigned the exact bit position in the signal by means of
●
The bit scale below the marker/control signal characteristic.
Baseband Signal - Baseband Block
To Next Page
Loading...
