Instrument Function
R&S
®
SMU200A
362Operating Manual 1007.9845.32 ─ 15
Start Select ← Data List Editor
Defines the current cursor position as the start position for the range to be marked. The
stop position is defined by entering an offset under "GoTo".
When a start position has been activated, the button will be re-labelled to "Undo
Select". When the button is clicked now, the selected range will be deactivated.
SCPI command:
n.a.
Copy ← Data List Editor
Copies the selected values.
SCPI command:
n.a.
Cut ← Data List Editor
Cuts the selected values.
SCPI command:
n.a.
Paste ← Data List Editor
Pastes the values that have been copied or cut before.
SCPI command:
n.a.
Hex ← Data List Editor
Switchover to hexadecimal display.
Each four bits are displayed as a hexadecimal value: To increase readability, the hexa-
decimal values in turn are displayed in pairs of two. The hex functions are automatically
assigned to the numeric keys at the front panel.
SCPI command:
n.a.
Save (Data List) ← Data List Editor
Saves the changes made to the Data List file selected for editing.
Baseband Signal - Baseband Block
To Next Page
Loading...
