Instrument Function
R&S
®
SMU200A
385Operating Manual 1007.9845.32 ─ 15
Multi Carrier
Calls the menu for calculating multi carrier waveforms (see chapter 5.8.4.3, "Multi Carrier
Waveforms", on page 412).
SCPI command:
n.a.
Trigger/Marker/Clock Settings
To access this dialog, select "Main Menu > Trigger/Marker".
The "Trigger In" section is where the trigger for the signal is set. Various parameters will
be provided for the settings, depending on which trigger source - internal or external - is
selected. The current status of signal generation ("Running" or "Stopped") is indicated
for all trigger modes.
The "Next Segmet Trigger In" is where the segment triggering is configured. This section
is enabled only for multi segment waferoms.
The "Marker Mode" section is where the marker signals at the MARKER output connec-
tors are configured.
The "Marker Delay" section is where a marker signal delay can be defined, either without
restriction or restricted to the dynamic section, i.e., the section in which it is possible to
make settings without restarting signal and marker generation.
Baseband Signal - Baseband Block
To Next Page
Loading...
