Instrument Function
R&S
®
SMU200A
413Operating Manual 1007.9845.32 ─ 15
The buttons in the middle part of the menu open submenus for defining the carrier table.
The carrier settings can be checked in the graphical "Carrier Graph" submenu.
The "Output Settings" section indicates the name, the size and the clock rate of the multi
carrier waveform (after calculation).
The buttons in the lower part of the menu activate creation and optionally loading of multi
carrier waveform files into the main ARB menu.
Default Settings and State
The upper part of the dialog is used for calling the default settings and saving and recalling
existing ARB multi carrier submenu settings.
Set to Default
Calls default settings. The values are shown in the following table.
Parameter Value
Number of Carriers 1
Carrier Spacing 0 MHz
Crest Factor Mode Off
Signal Period Mode Longest file wins
SCPI command:
[:SOURce<hw>]:BB:ARB:MCARrier:PRESet on page 608
Save/Recall Frame
Calls the "Save/Recall" menu.
Baseband Signal - Baseband Block
To Next Page
Loading...
