Remote Control Commands
R&S
®
SMU200A
603Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:ARB:MCARrier:CLOad <Cload>
This command creates a multi carrier waveform using the current entries of the carrier
table.
This multi carrier waveform is saved with the file name specified with command
SOUR:BB:ARB:MCAR:OFIL. The file extension is *.wv. Digital standard "ARB" is acti-
vated, the new multi carrier waveform is loaded and is output in accordance to the trigger
settings.
Parameters:
<file name><Cload>
MMEM:CDIR 'D:/user/waveform'
sets the default directory to D:/user/waveform.
BB:ARB:MCAR:OFIL 'mcar1_2'
defines the file name mcar1_2.wv for the multi carrier waveform.
BB:ARB:MCAR:CLO
creates multi carrier waveform mcar1_2.wv.
The new multi carrier waveform is loaded and digital standard
"ARB" is activated.
Example:
EventUsage:
[:SOURce<hw>]:BB:ARB:MCARrier:CLOCk?
The command queries the resulting sample rate at which the multi carrier waveform is
output by the arbitrary waveform generator. The output clock rate depends on the number
of carriers, carrier spacing and input sample rate of the leftmost or rightmost carriers.
Return values:
float<Clock>
BB:ARB:MCAR:CLOC?
queries the ARB multi carrier output clock rate.
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:ARB:MCARrier:CREate
This command creates a multi carrier waveform using the current settings of the carrier
table. The multi carrier waveform is saved into the file defined with command
SOUR:BB:ARB:MCAR:OFIL. The file extension is *.wv.
MMEM:CDIR 'D:/user/waveform'
sets the default directory to D:/user/waveform.
BB:ARB:MCAR:OFIL 'multi_wv1'
defines the file name multi_wv1.wv for the multi carrier wave-
form.
BB:ARB:MCAR:CRE
creates multi carrier waveform multi_wv1.wv.
Example:
SOURce Subsystem
To Next Page
Loading...
