Rohde & Schwarz SMU200A - Page 657

Remote Control Commands
R&S
®
SMU200A
637Operating Manual 1007.9845.32 ─ 15
BB:DM:FILT:OSAM 32
sets the upsampling factor to 32.
Example:
[:SOURce<hw>]:BB:DM:FILTer:OSAMpling:AUTO <Auto>
The command activates/deactivates the upsampling factor state. If activated, the most
sensible parameter values are selected. The value depends on the coherence check. If
deactivated, the values can be changed manually.
Parameters:
0|1|OFF|ON
ON
<Auto>
*RST:
BB:DM:FILT:OSAM:AUTO ON
The most sensible parameters are selected automatically.
Example:
[:SOURce<hw>]:BB:DM:FILTer:PARameter:COSine <Cosine>
[:SOURce<hw>]:BB:DM:FILTer:PARameter:GAUSs <Gauss>
[:SOURce<hw>]:BB:DM:FILTer:PARameter:LPASs <Lpass>
[:SOURce<hw>]:BB:DM:FILTer:PARameter:LPASSEVM <Lpassevm>
[:SOURce<hw>]:BB:DM:FILTer:PARameter:PGAuss <Pgauss>
[:SOURce<hw>]:BB:DM:FILTer:PARameter:RCOSine <Rcosine>
[:SOURce<hw>]:BB:DM:FILTer:PARameter:SPHase <Sphase>
[:SOURce<hw>]:BB:DM:FILTer:PARameter:APCO25 <Apco25>
The command sets the roll-off factor for filter type APCO25.
On selecting filter APCO25, the filter parameter is set to the default value.
SOURce Subsystem