Rohde & Schwarz SMU200A - Page 754

Remote Control Commands
R&S
®
SMU200A
734Operating Manual 1007.9845.32 ─ 15
IQ:OUTP:DIG:CDEV?
queries the connected device ID.
Example:
Query onlyUsage:
[:SOURce]:IQ:OUTPut:DIGital:OFLow:HOLD:RESet
This command executes a reset of the overflow hold state and LED.
SOUR:IQ:OUTP:DIG:OFL:HOLD:RESet
resets the overflow hold state.
Example:
EventUsage:
[:SOURce]:IQ:OUTPut:DIGital:OFLow:HOLD:STATe?
This command queries an overflow since the last reset. The overflow hold state can be
reset via the Reset button next to the LED, or is reset automatically by starting a new
signal generation or by setting new values to the output level.
Return values:
0|1|OFF|ON<State>
SOUR:IQ:OUTP:DIG:OFL:HOLD:STAT?
queries the overflow state.
Response: "0" (no overflow)
Example:
Query onlyUsage:
[:SOURce]:IQ:OUTPut:DIGital:OFLow:STATe?
This command queries the current overflow state of the output signal and indicates that
the I/Q output signal is currently clipped.
Return values:
0|1|OFF|ON<State>
IQ:OUTP:DIG:OFL:STAT?
queries the overflow state.
Response: "0" (no overflow).
Example:
Query onlyUsage:
[:SOURce<hw>]:IQ:OUTPut:DIGital:PON <Pon>
This command selects the state which the digital I/Q Output is to assume after the instru-
ment is switched on.
For two-path instruments the power-on state can be set separately for each path.
SOURce Subsystem