Preparing for Use
R&S
®
SMU200A
56Operating Manual 1007.9845.32 ─ 15
Setting up the VNC connection on the Linux/Unix remote computer
The VNC program is available per default for Linux/Unix operating systems.
1. Start a Web browser on the remote computer and enter the IP address of the instru-
ment.
2. Enter the following address:
vnc://<IP-address of the instrument>, e.g. vnc://192.168.1.1.
A dialog is opend and the pssword for the remote VNC connection is requested.
3. Enter the password as defined in the "Default Local System Properties" panel of the
Ultr@VNC program and select "Log On".
The connection is established, the instrument is remote accessed and the current
signal generator screen with the block diagram is displayed. The individual functions
are operated using the mouse and keyboard.
In contrast to remote access via Remote Desktop, the direct control of the instrument
is not disabled and the instrument can be controled from the front panel and via the
remote computer alternately.
Setting up the VNC connection on the Windows remote computer
1. Start VNC Viewer program component on the PC, select "VNC Server" and enter IP
address of the instrument.
2. To initialize the connection, select "Connect".
A message requesting the password appears.
3. Enter the password as defined in the "Default Local System Properties" panel of the
Ultr@VNC program and select "Log On".
The connection is established, the instrument is remote accessed and the current
signal generator screen with the block diagram is displayed. The individual functions
are operated using the mouse and keyboard.
Remote Access via an External Controller
To Next Page
Loading...
