Rohde & Schwarz SMU200A - Page 777

Remote Control Commands
R&S
®
SMU200A
757Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:LIST:POWer <Power>
The command fills the Level part of the selected list with data. The data can be given
either as a list of numbers (list can be of any length and list entries must be separated by
commas) or as binary block data. When block data is transferred, 8 (4) bytes are always
interpreted as a floating-point number with double accuracy (see the command
FORMat:DATA).
*RST does not affect data lists.
Parameters:
list of numbers | block data
-145 dBm to 30 dBm
dBm
<Power>
Range:
Default unit:
LIST:SEL 'D:/Lists/Listmode/list3'
selects list3 for editing. List3 is created if it does not yet exist.
LIST:POW 0dBm, 2dBm, 2dBm, 3dBm,..
specifies the level values in list3. The number of level values must
correspond to the number of frequency values. The previous data
is overwritten.
Example:
SCPI conformUsage:
[:SOURce<hw>]:LIST:POWer:AMODe <Amode>
(With Option High Power only)
The command selects the ranges of level settings for the list mode. The level settings are
either performed in the low level or in the high level ranges.
Parameters:
NORMal|HPOWer
NORMal
The level settings are made in the range of the electronically
switching attenuator. The high level ranges are not available.
HPOWer
The level settings are made in the range of the option. Only the
high level range is available.
NORMal
<Amode>
*RST:
LIST:POW:AMOD HPOW
selects the high level ranges for List Mode.
Example:
[:SOURce<hw>]:LIST:POWer:POINts?
The command queries the length (in points) of the LEVel part of the selected list.
Return values:
float<points>
SOURce Subsystem