Rohde & Schwarz SMU200A - Page 778

Remote Control Commands
R&S
®
SMU200A
758Operating Manual 1007.9845.32 ─ 15
LIST:SEL 'D:/Lists/Listmode/list3'
selects list3 for editing. List3 is created if it does not yet exist.
LIST:POW:POIN?
queries the number of levels in list3.
Response: 327
LIST2 has 327 level entries.
Example:
Query only
SCPI conform
Usage:
[:SOURce<hw>]:LIST:RESet
The command resets the list to the starting point.
LIST:RES
resets the list to the starting point.
Example:
EventUsage:
[:SOURce<hw>]:LIST:SELect <Select>
The command selects the specified list. If a new list is to be created, the name can be
entered here. The list is created if it does not yet exist. The list selected here is available
for the further processing steps (editing) and is used in the instrument when the List mode
is activated.
The files are stored with the fixed file extensions *.lsw in a directory of the user's choice.
The directory applicable to the command is defined with the command MMEMory:CDIR.
A path can also be specified in command :SOUR:LIST:SEL in which case the list mode
file in the specified directory is selected.
*RST does not affect data lists.
Parameters:
'<list name>'<Select>
LIST:SEL 'D:/Lists/Listmode/list3'
selects list3 for editing. List3 is created if it does not yet exist.
Example:
[:SOURce<hw>]:LIST:TRIGger:EXECute
The command immediately starts the processing of a list in list mode. It corresponds to
the manual-control command "Execute Single."
SOUR:LIST:TRIG:EXEC
triggers the processing of the selected list.
Example:
EventUsage:
SOURce Subsystem