Rohde & Schwarz SMU200A - Page 816

Remote Control Commands
R&S
®
SMU200A
796Operating Manual 1007.9845.32 ─ 15
Improper use could destroy the assembly!
The respective hardware assembly responds directly to the :TEST:DIRect command;
any safety mechanisms are bypassed. The command is used for servicing purposes and
should not be applied by the user.
:TEST:BB:CONNection...................................................................................................796
:TEST:BBIN...................................................................................................................796
:TEST<hw>:BBIN:RBERror.............................................................................................796
:TEST<hw>:BBOut:LRATe..............................................................................................797
:TEST<hw>:BBOut:TTESt[:STATe]..................................................................................797
:TEST:CONNector:AUXio...............................................................................................797
:TEST<hw>:DIRect........................................................................................................798
:TEST:FADer.................................................................................................................798
:TEST:BB:CONNection?
The command performs a connection test on each of the internal digital baseband links.
This implies all installed options as baseband inputs, motherboard, universal coding gen-
erators, fading simulators, and baseband outputs.
Return values:
0|1|OFF|ON<Connection>
TEST:BB:CONNection?
Response: "0" on success, "1" on fail
Example:
Query onlyUsage:
:TEST:BBIN?
This command performs a selftest on the baseband input hardware options. Several
analog diagnostics points are checked to verify the correct function of the module.
Return values:
0|1|OFF|ON<Bbin>
TEST:BBIN?
Response: "0" on success, "1" on fail
Example:
Query onlyUsage:
:TEST<hw>:BBIN:RBERror?
This command performs a bit error rate test of the received test signal.
Return values:
0|1<Rberror>
TEST Subsystem