Siemens SINAMICS G120 - r2130[0...63] Fault time received in days; t_fault recv days; r2131 CO: Actual fault code; Actual fault code; r2132 CO: Actual alarm code; Actual alarm code; r2133[0...63] Fault value for float values; Fault val float

To Next Page

To Previous Page

List of Parameters

Parameters

1-281

SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011

Description: Displays the system runtime in days when the fault occurred.

Dependency: Refer to: r0945, r0947, r0948, r0949, r2109, r2133, r2136

Notice: The time comprises r2130 (days) and r0948 (milliseconds).

The value displayed in p2130 refers to 01.01.1970.

Note: The buffer parameters are cyclically updated in the background (refer to status signal in r2139).

Description: Displays the code of the oldest active fault.

Dependency: Refer to: r3131, r3132

Note: 0: No fault present.

Description: Displays the code of the last alarm that occurred.

Note: 0: No alarm present.

Description: Displays additional information about the fault that occurred for float values.

Dependency: Refer to: r0945, r0947, r0948, r0949, r2109, r2130, r2136

Note: The buffer parameters are cyclically updated in the background (refer to status signal in r2139).

Description: Displays additional information about the active alarm for float values.

Dependency: Refer to: r2110, r2122, r2123, r2124, r2125, r2145, r2146

Note: The buffer parameters are cyclically updated in the background (refer to status signal in r2139).

r2130[0...63] Fault time received in days / t_fault recv days

Access level: 3 Calculated: - Data type: Unsigned16