Siemens SINAMICS G120 - 2.11 Vector control

Function diagrams
Vector control
2-586
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
2.11 Vector control
Function diagrams
6030 – Speed setpoint, droop 2-587
6031 – Pre-control balancing, acceleration model 2-588
6040 – Speed controller 2-589
6050 – Kp_n/Tn_n adaption 2-590
6060 – Torque setpoint 2-591
6220 – Vdc_max controller and Vdc_min controller (Vector control, PM230 / PM240) 2-592
6490 – Speed control configuration 2-593
6491 – Flux control configuration 2-594
6630 – Upper/lower torque limit 2-595
6640 – Current/power/torque limits 2-596
6710 – Current setpoint filter 2-597
6714 – Iq and Id controllers 2-598
6721 – Id setpoint (PEM, p0300 = 2xx) 2-599
6722 – Field weakening characteristic, Id setpoint (ASM, p0300 = 1) 2-600
6723 – Field weakening controller, flux controller (ASM, p0300 = 1) 2-601
6724 – Field weakening controller (PEM, p0300 = 2xx) 2-602
6730 – Interface to the Power Module (ASM, p0300 = 1) 2-603
6731 – Interface to the Power Module (PEM, p0300 = 2xx) 2-604
6799 – Display signals 2-605