Siemens SINAMICS G120 - p20089 NOT 2 run sequence; NOT 2 RunSeq; p20090 BI: NOT 3 input I; NOT 3 input I; r20091 BO: NOT 3 inverted output; NOT 3 inv output; p20092 NOT 3 run-time group; NOT 3 RTG

To Next Page

To Previous Page

Parameters

List of Parameters

1-408

SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011

Description: Setting parameter for the run sequence of instance NOT 2 within the run-time group set in p20088.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of input quantity I of instance NOT 3 of the inverter.

Description: Display parameter for the inverted output of instance NOT 3 of the inverter.

Description: Setting parameter for the run-time group in which the instance NOT 3 of the inverter is to be called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance NOT 3 within the run-time group set in p20092.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

p20089 NOT 2 run sequence / NOT 2 RunSeq

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: T Scaling: - Data set: -