Siemens SINAMICS G120 - r20134 CO: AVA 1 output Y; AVA 1 output Y; r20135 BO: AVA 1 input negative SN; AVA 1 input neg SN; p20136 AVA 1 run-time group; AVA 1 RTG; p20137 AVA 1 run sequence; AVA 1 RunSeq

List of Parameters
Parameters
1-417
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Description: Display parameter for output quantity Y of instance AVA 1 of the absolute value generator with sign evaluation.
Description: Display parameter for signal SN that the input quantity X of instance AVA 1 of the absolute value generator with
sign evaluation is negative.
X < 0.0 => SN = 1
Description: Setting parameter for the run-time group in which instance AVA 1 of the absolute value generator with sign evalua-
tion is to be called.
Value: 5: Run-time group 5
6: Run-time group 6
9999: Do not calculate
Description: Setting parameter for the run sequence of instance AVA 1 within the run-time group set in p20136.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
Description: Sets the signal source for the input pulse I of instance MFP 0 of the pulse generator.
r20134 CO: AVA 1 output Y / AVA 1 output Y
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - -
r20135 BO: AVA 1 input negative SN / AVA 1 input neg SN
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - -
p20136 AVA 1 run-time group / AVA 1 RTG
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
5 9999 9999
p20137 AVA 1 run sequence / AVA 1 RunSeq
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
0 32000 350
p20138 BI: MFP 0 input pulse I / MFP 0 inp_pulse I
Access level: 3 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - 0