Siemens SINAMICS G120 - p20050[0...3] BI: OR 1 inputs; OR 1 inputs; r20051 BO: OR 1 output Q; OR 1 output Q; p20052 OR 1 run-time group; OR 1 RTG; p20053 OR 1 run sequence; OR 1 RunSeq

List of Parameters
Parameters
1-399
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Description: Sets the signal source of input quantities I0, I1, I2, I3 of instance OR 1 of the OR function block.
Index: [0] = Input I0
[1] = Input I1
[2] = Input I2
[3] = Input I3
Description: Display parameter for binary quantity Q = I0 | I1 | I2 | I3 of instance OR 1 of the OR function block.
Description: Setting parameter for the run-time group in which the instance OR 1 of the OR function block is to be called.
Value: 1: Run-time group 1
2: Run-time group 2
3: Run-time group 3
4: Run-time group 4
5: Run-time group 5
6: Run-time group 6
9999: Do not calculate
Description: Setting parameter for the run sequence of instance OR 1 within the run-time group set in p20052.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20050[0...3] BI: OR 1 inputs / OR 1 inputs
Access level: 3 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - 0
r20051 BO: OR 1 output Q / OR 1 output Q
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - -
p20052 OR 1 run-time group / OR 1 RTG
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
1 9999 9999
p20053 OR 1 run sequence / OR 1 RunSeq
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
0 32000 70