Siemens SINAMICS G120 - r9409 Number of parameters to be saved; Qty par to save; r9451[0...29] Units changeover adapted parameters; Unit_chngov par; r9463 Set valid macro;; p9484 BICO interconnections search signal source; BICO S

To Next Page

To Previous Page

Parameters

List of Parameters

1-346

SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011

Description: Displays the number of modified parameters and those that have still not be saved for this drive object.

Dependency: Refer to: p0971

Note: The modified parameters that still need to be saved are internally listed in r9410 ... r9419.

Description: Displays the parameters whose parameter would have to be changed during a units changeover.

Dependency: Refer to: F07088

Description: Displays the valid macro.

A value of 0 is displayed if a parameter set by a macro is changed.

Description: Sets the signal source (BO/CO parameter, BICO coded) to search in the signal sinks.

The signal source to be searched for is set in p9484 (BICO-coded) and the search result is specified using the num-

ber (r9485) and the first index (r9486).

Dependency: Refer to: r9485, r9486

Description: Displays the number of BICO interconnections to the signal sink being searched for.

Dependency: Refer to: p9484, r9486

Note: The signal source to be searched is set in p9484 (BICO-coded).

The search result is contained in r9482 and r9483 and is specified by the count (r9485) and the first index (r9486).

r9409 Number of parameters to be saved / Qty par to save

Access level: 4 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Data set: -