Siemens SINAMICS G120 - p0595 Selecting technological units; Select tech units

Parameters
List of Parameters
1-78
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Description: Selects the units for the parameters of the technology controller.
Value: 1: %
2: 1 referred, no dimensions
3: bar
4: °C
5: Pa
6: ltr/s
7: m³/s
8: ltr/min
9: m³/min
10: ltr/h
11: m³/h
12: kg/s
13: kg/min
14: kg/h
15: t/min
16: t/h
17: N
18: kN
19: Nm
20: psi
21: °F
22: gallon/s
23: inch³/s
24: gallon/min
25: inch³/min
26: gallon/h
27: inch³/h
28: lb/s
29: lb/min
30: lb/h
31: lbf
32: lbf ft
33: K
34: rpm
35: parts/min
36: m/s
37: ft³/s
38: ft³/min
39: BTU/min
40: BTU/h
41: mbar
42: inch wg
43: ft wg
44: m wg
45: % r.h.
46: g/kg
Dependency: Only units of parameters with unit group 9_1 can be changed over using this parameter.
Refer to: p0596
p0595 Selecting technological units / Select tech units
Access level: 1 Calculated: - Data type: Integer16
Can be changed: C(5) Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
1 46 1